International Journal

In this paper, a microstrip lowpass filter with wide stopband and sharp roll-off is presented. The proposed filter consists of a modified radial stub resonator which is cascaded by four suppressing cells. To reduce the overall size, the transmission lines are folded. The cut-off frequency of the proposed filter is 1.19 GHz. The transition band is approximately 0.2 GHz from 1.19 to 1.39 GHz with co

Design and realisation of a compact power divider based on half mode substrate integrated waveguide (HMSIW) with an arbitrary power dividing ratio is presented. This design consists of a substrate integrated waveguide (SIW) transition, two bisected HMSIW transitions by a gap, an SIW-to-microstrip transition, and two microstrip feed lines. In addition, a resistor is attached between two HMSIW trans

This paper presents a new broad band circularly polarized slot antenna array based on substrate-integrated waveguide (SIW) and aperture feeding techniques. The antenna element's impedance and 3 dB axial-ratio (AR) bandwidths are from 8.8 to 10.4 GHz (16.67%) and 9.5?10.7 GHz (12%), respectively. Employing aperture-coupled feed and combining this method with sequentially rotated network, a 2 × 2 an

Novel impedance transforming directional couplers are proposed in which the achievable impedance transformation ratio is increased above the previously reported limit related to coupling of the coupled-line sections. The proposed couplers consist of two coupled-line sections between which uncoupled sections of left-handed lines are connected. The presented concept has been verified by circuit simu

This paper presents a high gain, wideband circularly polarized (CP) antenna. High gain of the antenna is achieved by employing a frequency selective surface (FSS) as a reflector. The antenna is a coplanar waveguide-fed structure with a modified L-shaped radiating patch. The unit element of the FSS is formed by connecting two modified dipoles at an angle of 90°. The antenna with reflector has a mea

We report in this paper a novel miniaturized (12 × 18 × 1.6 mm) microstrip fed UWB antenna with tunable notched band characteristics. The proposed antenna covers the tunable notched band for IEEE 802.11a wireless local area network operating in the frequency band of 5.15?5.825 GHz. The design of proposed antenna includes annular ring radiating patch with two T-shaped strips present inside it. The

This paper presents the design of a compact, planar, single layer, tri-section ultra-wideband (UWB) branch-line (BL) coupler. The prototype offers 10 dB return loss characteristics from 3.1 to 13.7 GHz. Over a major portion of the band, phase imbalance of ±10° is achieved. The method of deploying multi stage impedance feed has been used to achieve improved bandwidth. To enhance the power output th

A single-layer coaxial-fed compact rectangular microstrip antenna with very low voltage standing wave ratio (VSWR) is presented in this paper. The simulated VSWR of the proposed antenna 1.00374 is obtained near the center frequency of the operating band (3.5 GHz). Simulation and measurement results indicate that the bandwidth (simulated: 3.36?3.715 GHz, and measured: 3.295?3.645 GHz) of the antenn

Aperture-coupled ESPAR antenna with a unique feed structure for switched beam application has been presented. The feed structure provides control over surface current of the driven element with the help of which main lobe can be steered in desired direction. This control has been achieved through the use of PIN-diodes. Finite element method has been utilized for design and simulated and measured r

A compact coplanar waveguide (CPW)-fed wideband metamaterial-inspired antenna is designed and developed in this paper. The proposed structure is an asymmetric structure in which three rectangular stubs are employed between signal patch and CPW ground plane. It is demonstrated that these stubs provides lumped parameters of conventional epsilon-negative transmission line (ENG-TL). As an advantage of