International Journal
1993 documents found.
A 219?266 GHz LO-tunable direct-conversion IQ receiver module in a SiGe HBT technology
Published online : 01-06-2018
Access
View abstract
This paper presents a fully-integrated direct-conversion fundamentally-operated mixer-first quadrature receiver module with a tunable LO in the 219?266 GHz band. It has been implemented in a 0.13-?m SiGe heterojunction bipolar transistor technology. It includes an on-chip LO path driven externally from the printed circuit board (PCB) connector level at 13.6?16.7 GHz. A hybrid coupler generates the
Automotive antenna diversity system for satellite radio with high phase accuracy in low SNR-scenarios
Published online : 01-06-2018
Access
View abstract
For a fast scan-phase satellite radio antenna diversity system a noise correction method is presented for a significant improvement of audio availability at low signal-to-noise ratio (SNR) conditions. An error analysis of the level and phase detection within the diversity system in the presence of noise leads to a correction method based on a priori knowledge of the system's noise floor. This meth
Analysis of multipath and DOA detection using a fully polarimetric automotive radar
Published online : 01-06-2018
Access
View abstract
Multipath propagation occurs in many situations of radar measurements in complex environments. The unwanted effects range from interference over the radar channels, which causes amplitude fading and a corrupted direction of arrival (DOA) estimation, to the detection of ghost targets in an angle of arrival of the multipath direction. Due to the different number of reflections, polarimetric radars a
A 216?256 GHz fully differential frequency multiplier-by-8 chain with 0 dBm output power
Published online : 01-06-2018
Access
View abstract
This work presents a fully differential wideband and low power 240 GHz multiplier-by-8 chain, manufactured in IHP's 130 nm SiGe:C BiCMOS technology with / = 300/500 GHz. A single ended 30 GHz input signal is multiplied by 8 using Gilbert cell-based quadrupler and doubler, and then amplified with a wideband differential 3-stage cascode amplifier. To achieve wide bandwidth and optimize for power con
Scanning microwave microscopy of buried CMOS interconnect lines with nanometer resolution
Published online : 01-06-2018
Access
View abstract
This paper reports scanning microwave microscopy of CMOS interconnect aluminum lines both bare and buried under oxide. In both cases, a spatial resolution of 190 ± 70 nm was achieved, which was comparable or better than what had been reported in the literature. With the lines immersed in water to simulate high- dielectric, the signal-to-noise ratio degraded significantly, but the image remained as
KIT coaxial gyrotron development: from ITER toward DEMO
Published online : 01-06-2018
Access
View abstract
Karlsruhe Institute of Technology (KIT) is doing research and development in the field of megawatt-class radio frequency (RF) sources (gyrotrons) for the Electron Cyclotron Resonance Heating (ECRH) systems of the International Thermonuclear Experimental Reactor (ITER) and the DEMOnstration Fusion Power Plant that will follow ITER. In the focus is the development and verification of the European co
Radiometric accuracy and stability of sentinel-1A determined using point targets
Published online : 01-06-2018
Access
View abstract
Sentinel-1A is a space-borne synthetic aperture radar (SAR) system developed in the frame of the Copernicus Program. The German Aerospace Center supported the radiometric and polarimetric calibration of Sentinel-1A by the analysis of point target responses of several acquisitions considering different modes, beams, and polarization channels. An elevation dependent bias, which had not been properly
Slow-wave coplanar waveguides based on inductive and capacitive loading and application to compact and harmonic suppressed power splitters
Published online : 01-06-2018
Access
View abstract
In this paper, a slow-wave transmission line implemented in coplanar waveguide technology, based on simultaneous inductive and capacitive loading, is presented for the first time. The shunt capacitors are achieved by periodically etching transverse strips in the back substrate side, connected to the central strip through metallic vias. The series inductors are implemented by etching rectangular sl
Comparative study of envelope models for hybrid time- and frequency-domain simulation of traveling-wave tubes
Published online : 01-06-2018
Access
View abstract
A selection of hybrid frequency- and time-domain approaches is evaluated with respect to their suitability for predicting the multi-tone behavior of a reference Ku-band helix traveling-wave tube. For this, a frequency-domain code is extended by a selection of frequency-dependent and frequency-independent envelope models and compared to a number of simulated and measured responses to two-tone signa
MRF volume 10 issue 4 Cover and Back matter
Published online : 01-05-2018
Access