International Journal

This paper presents a novel balanced-to-balanced power divider (PD) based on a simple and compact three-line coupled structure for the first time. By bisecting the proposed symmetrical structure, the differential mode (DM) and the common mode (CM) equivalent circuits can be obtained for analysis. The DM equivalent circuit exhibits a three-line in-phase power dividing response, and then a resistor

A shorted magneto electric dipole with orthogonal dual polarization is designed for modern wireless communications. The proposed antenna is a wideband dual-polarized antenna consisting of magneto electric dipoles, which are fed by novel hook-shaped strip feeds. The antenna proposed in this paper is simulated using EM simulation software called high-frequency structure simulator. The simulated and

Though compact polarimetric approaches have been developed and applied in space and geo researching systems they have not been taken into consideration in automotive applications, yet. A sensor system has been designed to conduct polarimetric measurements in the 77 GHz frequency band, which is permitted for automotive usage. This system is able to transceive linearly as well as circularly polarize

A novel online antenna array calibration method is presented in this paper for estimating direction-of-arrival (DOA) in the case of uncorrelated and coherent signals with unknown gain-phase errors. Conventional calibration methods mainly consider incoherent signals for uniform linear arrays with gain-phase errors. The proposed method has better performance not only for uncorrelated signals but als

In this paper, design and development of a via-free composite right/left handed transmission line (CRLH TL)-based diplexer for WiMAX and WLAN bands is reported. The diplexer is having two channels, where each channel consists of a separate bandpass filter (BPF). The BPF of both channels are designed on via-free CRLH TLs based on a newly proposed right-angled corner-modified split ring resonator (R

This paper specifies a concise review of recent research and development in the context of electromagnetic absorbers. An attempt has been made to justify the need for economical and thin microwave absorbers for achieving good absorption characteristics over a wide range of frequencies within a specified band of electromagnetic spectrum. This paper mainly focuses on the challenges encountered while

In this paper, the design of a graded honeycomb radar absorbing structure (RAS) is presented to realize both a wide bandwidth and absorption over a wide range of angles. For both transverse-electric and transverse-magnetic polarization, a fractional bandwidth of more than 118.6% is achieved for at least a 10 dB reflectivity reduction when the incident angle is <45°, an 8 dB reduction when the inci

This paper proposes a microstrip antenna with reduced in-band and out-of-band radar cross-section (RCS) by subtracting the area of weak scattered current on the ground plane. Fourteen square slots were subtracted from the ground plane, reducing in-band and out-of-band RCS while maintaining radiation performance. Modified and reference antenna surface current distributions were simulated and analyz

In this article, the material distributive topology-based design optimization of ultra-wide band (UWB) antenna is proposed by using improved binary particle swarm optimization (BPSO) with finite difference time domain (FDTD) method. In the improved BPSO implementation, the velocity of each particle is calculated based on complete set of bits of particle position vector. The V-shaped transfer funct

This paper presents a compact microstrip antenna using FR-4 substrate for dual band circularly polarized operation using a modified square ring slot in the ground plane with microstrip line feed. Simulation of the impedance characteristic and radiation characteristic for the proposed antenna is carried out using commercially available HFSS software. The simulated data validate measured results and