International Journal

A polar transmitter driven by digital input signals for envelope and phase is demonstrated, using a band-switching output resonator to achieve multiband operation. A new digital pulse width modulation algorithm is also shown to partially suppress spurious signals associated with the digital input envelope signal. The transmitter consists of a current-mode class-D (CMCD) CMOS power amplifier (PA),

We present the design, fabrication, and measurement of a 2-way modified Wilkinson divider constructed in a coplanar geometry exhibiting ultra wideband isolation, transmission, and port matching in the millimeter-wave frequency range. The proposed divider replaces the lumped resistor in the conventional Wilkinson divider with two quarter-wave length transmission lines, a phase inverter, and two 2Z

The implementation and application of single-layer fully-planar extended-composite right-/left-handed transmission lines (E-CRLH TLs) in substrate-integrated waveguide (SIW) technology are presented. The multiband CRLH behavior of these artificial lines is explained by considering the lumped element equivalent circuit model. The potential of these lines for dual-band and quad-band applications is

The design and characterization of a new broadband small patch antenna, based on an innovative magneto-dielectric material and suitable for wearable applications at 868 MHz, is presented. To reduce antenna dimensions, while preserving its radiation and matching performance, a barium-strontium hexaferrite BaSrFeO has been synthesized as the antenna substrate to achieve magnetic permeability double

This paper reports on digital transmitter architecture for the 450 MHz band using an envelope delta-sigma modulator realized in CMOS and a voltage-mode class-S (VMCS) power amplifier (PA) based on GaN monolithic microwave integrated circuits (MMICs). The class-S PA is characterized for narrowband single-tone signals and a single- as well as a four-carrier downlink wideband code division multiple a

Resonant substrate integrated near-field sensors are used for characterization of aqueous solutions at three different frequencies. In addition, Chinese hamster ovary (CHO) cells in a culture medium are characterized with the same sensors. Different concentrations as well as different vital states of cell suspensions are examined. The complex permittivity of the samples is evaluated using a linear

A millimeter-wave monolithic integrated circuit consisting of a W-band (75?100 GHz) single-pole-five-throw (SP5T) switch and multiple internal active and passive loads for radiometer calibration was designed and manufactured in a low noise 50 nm GaAs metamorphic high electron mobility transistor technology. This highly compact and integrated front-end device for radiometer systems is capable of ul

This paper reports on the design of a new power cell dedicated to Ku-band power amplifier (PA) applications. This cell called ?integrated cascode? has been designed in order to propose a strong decrease in terms of circuit size for PA. The technology used relies on 0.25-?m GaAs pseudomorphic high electron mobility transistors (PHEMT) of United Monolithic Semiconductors (UMS) foundry. A distributed

This paper presents a novel technology for the implementation of substrate-integrated waveguide (SIW) structures, based on a paper substrate and realized by an inkjet-printing fabrication process. The use of paper permits to implement low-cost microwave structures and components, by adopting a completely eco-friendly implementation technology. SIW structures appear particularly suitable for implem

In this paper, we present a non-resonant high impedance reflectometer with a reference impedance close to one of the tip probe of a near-field microwave microscope. We show that for an apex of the tip probe of 100 µm there is an optimum reference impedance close to 1 k?. To validate this approach a microwave circuit that makes use of lumped elements has been fabricated. A proof of concept is also